Prev Next Hendrickson — RS Description This walking beam suspension is most often found on cement mixer trucks. The OE rubber load springs are usually found to have taken significant compression set due to their inability to withstand the acid wash used to clean lime off the suspension. The acid attacks and weakens the rubber, compromising its ability to sustain the load. ATRO polyurethane is impervious to chemical attack. Hendrickson RS Fast Facts Hendrickson — RS Type Walking beam suspension Features Problem Areas The OE rubber load springs are usually found to have taken significant compression set due to their inability to withstand the acid wash used to clean lime off the suspension. ATRO Solutions Tech Tips and Additional Resources On the RS, ATRO’s load pads are made of a proprietary low rebound (no-bounce) material to absorb shock and limit its transfer to the frame. To accomplish this with rubber, the OE traditionally offers two different part numbers of varying hardness for specific applications. ATRO’s one part number will perform reliably in any application. ATRO center bushings require thrust washers ATRO bushings have free-rotation design Eases installation Automatically zeroes out to ride height Wear Items Rubber springs – due to chemical attack causing dry rot and compression set Walking beam bushings – both bar pin end bushings and centers Torque rod/bushings – check all, especially transverse rod Key Parts Torque Rods are availble in any length, or as two-piece rods. Rebound Control Kit BM50-66208 All Products Center Bushing Kit CB38011 CB38012 All Products Beam End Bushing EB38000 All Products Bar Pin Bushing Kit EB50-21013 All Products Center Load Cushion HC10000 All Products Load Cushion HC20000 All Products Vertical Bushing HV38000 All Products Torque Rod Bushing TS38000 All Products Details Hendrickson RS Walking beam suspension with ATRO HC20000 Load Cushions, HC10000 HD Center Load Cushion, and Center Bushing Kit. Prev Next