Prev Next Hendrickson — Haulmaax Description This walking beam suspension is similar in design to the Hendrickson HN suspension. It features bar pin end bushings but there are no center bushings for the beams to pivot on. Like the HN, the traditional center bushing is replaced by 4 narrow bolster springs (8 per vehicle.) The center of gravity has been lowered by designing the narrow bolster to straddle the beam in pairs compared to the HN where large single bolsters are mounted atop the walking beam. Hendrickson Haulmaax Fast Facts Hendrickson — Haulmaax Type Walking beam suspension Features Problem Areas ATRO Solutions Tech Tips and Additional Resources Kits: A key element in an efficient repair is having all the key parts and components. The KT50-25002 or KT50-25003 are complete kits with hardware for bolster spring repairs. The EB50-21013, bar pin in-bushing kit, contains all the necessary bolts, nuts, shim and washers. Look for detailed installation instructions by searching for EB50-21013. KT50-25002 KT50-25003 (includes wear plates) EB50-21013 ATRO’s polyurethane material in the bolster springs and progressive auxiliary spring is impervious to chemical attack. The new style LP50-24778, Progressive Auxiliary Spring, replaced the smaller old style auxiliary spring, LP50-24974, in 2014. It is important to replace the old style with the new style on both sides of the truck. To install the new style progressive auxiliary spring it may be necessary to remove shim and/or raise the frame. Load spring is not an overload spring or a bump stop and it is designed to carry up to 40% of the load Properly installed it is in contact with the contact plate on the saddle 100% of the time Wear Items Transverse rods are critical, especially in high center of gravity applications like dump trucks and concrete mixers. Check periodically for wear Check bolsters for cracks/debonds Replace if material is cut 1" length or 3/8" in depth Replace if bond separation is >1/2" deep The most common root causes of cracked or broken frame brackets: Vehicle is overloaded Worn transverse torque rods Frame bracket bolts/fasteners are loose Auxiliary spring is worn Failure Analysis: A debond of a bolster spring may be a secondary failure and the location of a debond can help locate the source of the root cause. Location Possible Primary Failure Point Debond at top plate Check torque rods for bushing failure Debond at lower plate Check bar pin end bushing for failure Key Parts Torque Rods are availble in any length, or as two-piece rods. Bushing Kit EB50-21013 All Products Suspension Kit / Bolster Spring Kit KT50-25003 KT50-25002 LP50-24179 All Products Progressive Load Spring Kit LP50-24745 All Products Auxillary Shim MS50-29791 All Products Torque Rod Bushing TS38000 All Products Torque Rod Bushing TS50-22691 PL1146 (No Rim) All Products Tapered Torque Rod Bushing TT38000 All Products Tapered Torque Rod Bushing TT50-22697 All Products